澳洲幸运10官方开奖结果

  • Tape die cuts for anodizing

澳洲幸运10开奖结果查询

A small job shop that does aluminum CNC milling contacted Viadon to see about a custom die cut "kit" that could mask portions of a part they were making before it went to their anodizer. We worked with this job shop to design some very small, intricate die cut shapes - some as narrow as 0.062" in width. But before they committed the money to buy a tool, the job shop wanted to test the die cuts first.

Our response: "No problem!"

Viadon routinely provides custom die cut tape samples to metal finishers (and even custom aluminum machining job shops!). This allows the customer to test custom parts for fit and performance first.

Check out the die cut shapes and note how small they are compared to the standard-sized paper clip above them.

We showed them how to use a small hobby-type knife blade to peel the parts off the clear liner/backing to minimize finger-oil contamination, then place the tape die cut on to the metal itself. And for successful anodizing masking, the tape must be pushed down hard to let the adhesive flow for full stop-off over the next 24 hours. We made sure they were aware of that important aspect of anodizing masking. Otherwise, the anodizing may "creep" under the edge of the tape, and cause an uneven look to the masked area.

And how did it go with this set of die cuts? - Superbly.

Another Viadon success story!
Not only did the samples work just as planned, the job shop ordered the tooling to make 1,500 more sets. This saved them a lot of time (and money!) on labor to mask off the tiny surface areas that could not be anodized.

How can Viadon help your company save time and money for your metal finishing process? Give us a call today with your next challenging project, at 866-534-3900.

SG赛车计划网 澳洲幸运5开奖官方同步 秒速赛车计划 SG赛车龙虎和走势图